Quick disconnects for your WK and XK front sway bar with a 4" SuperLift kit. Quick disconnects allow you to temporarily disconnect your front swaybar for up to 30% more axle articulation and dramatically improve off-road performance.
- Increases suspension travel Heavy gauge steel construction
- Adjustable, threaded body
- Convenient "click-pins"
- Stainless-steel mounting post
Installation clamp Only at Jeepin by AL To install: Unbolt the stock links, install the two SS studs, install the new link, press bushing with clamp tool, install pin and snap over the D ring, move to the other side and repeat.
Max length is 16.87"
|Show JBA UCAs Only||N/A|
- Fit perfectly with no play at all Review by Mark
It took about 10 minutes to install after old links were out.
Made of thick steel with tight bushings.
There isn't any play in the bushings at all. Tight tolerances.
Came with a small cable to hold up disconnect, but instructions are baffling. I'm guessing its a generic part/instruction as there is no way to only disconnect one link end and swing it up out of the way on a 2005-2007 WK. You have to remove both links completely.
(Posted on 9/5/2016)